96 Saab 900 blower motor

1996 SAAB 900
172,000 MILES • 4 CYL • 2WD • MANUAL
Avatar
PORTEOUS
  • MEMBER
  • 4 POSTS
New OEM blower motor,new fan speed controller. ACC shows 0 faults on two different units and fan connector shows 12.1 volts when fan is disconnected. Blower Motor still doesn't work?
May 31, 2011 at 2:46 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
RASMATAZ
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 75,992 POSTS
Power the blower motor from the battery if it comes On-check if it has a blower resistor/relay if so test it-
Jun 1, 2011 at 12:36 AM
Advertisement
Avatar
MNTHNY4
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 612 POSTS
OK U NEED TO REPLACE THE CONTROL PANEL ,IF U TAKE CONTROL PANEL OUT & LOOK AT THE BACK SECTION WHERE ELECTRICAL CONNECTOR GOES U SHOULD SEE THAT IT'S BURNT ,MOST OF THE TIMES THAT IS THE ISSUE WITH THAT MODEL AS PER A/C FUNCTION,GOOD LUCK.
Jun 7, 2011 at 5:17 PM