I have a 1996 nissan 200sx/se with a 1.6l motor please tell me the procedure on water pump removal !!! thanx sincerely dale.
Dec 15, 2010 at 2:14 AM
water pump r and r
1996 NISSAN 200SX
DALE7492
- MEMBER
- 1 POST
Advertisement
KHLOW2008
- ✓ASE Certified Mechanic
- 41,814 POSTS
WATER PUMP
Removal
Drain coolant from radiator and cylinder block (drain plug is on left side of block, between flywheel and exhaust manifold).
Remove accessory drive belts.
Remove water pump pulley and water pump.
DO NOT allow coolant to contact accessory drive belts.
Remove all gasket material from pump housing mating surfaces.
Installation
Apply a small bead of liquid gasket to pump housing mating surface.
Install pump.
To install remaining components, reverse removal procedure.
Tighten all nuts and bolts to specification.
© 2008 Mitchell Repair Information Co., LLC.
Removal
Drain coolant from radiator and cylinder block (drain plug is on left side of block, between flywheel and exhaust manifold).
Remove accessory drive belts.
Remove water pump pulley and water pump.
DO NOT allow coolant to contact accessory drive belts.
Remove all gasket material from pump housing mating surfaces.
Installation
Apply a small bead of liquid gasket to pump housing mating surface.
Install pump.
To install remaining components, reverse removal procedure.
Tighten all nuts and bolts to specification.
© 2008 Mitchell Repair Information Co., LLC.
Dec 17, 2010 at 11:28 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.