where is the inertia switch located for 1996 mitsubishi expo?
Feb 15, 2012 at 6:02 PM
inertia switch for a 1996 expo?
1996 MITSUBISHI EXPO
MURIELPOOLE
- MEMBER
- 1 POST
Advertisement
It doesn't come with it-sure its not the fuel pump relay you're looking for?
Feb 15, 2012 at 6:21 PM
The Expo wasn't available in the US at that time, so our reference doesn't list it. I checked all vehicles that were available at the time and none have an inertial cutoff switch.
However, from experience, most are either located in the driver side rear of the trunk or the driver side kick panel area.
However, from experience, most are either located in the driver side rear of the trunk or the driver side kick panel area.
Feb 15, 2012 at 6:24 PM
grrrr
Feb 15, 2012 at 6:24 PM
lol -when you snooze -you lozzzyyyy -----------
Feb 15, 2012 at 6:42 PM
But I didn't snooze. It didn't say anyone else was working on this question when I opened it.
Feb 15, 2012 at 8:39 PM
Blame it on the programming its still acting up-that's why I was invisible to you.many times were 2secs apart on a question-Can you do something about it very aggravating causing me to say ....t or grrrrrr from you-lol
Just keep up the good work and keep answering, there's more coming our way-I'll race you to it anytime. anywhere,anyplace-lol bye JimBob
Just keep up the good work and keep answering, there's more coming our way-I'll race you to it anytime. anywhere,anyplace-lol bye JimBob
Feb 15, 2012 at 10:02 PM
lol. Later bro.
Feb 15, 2012 at 10:10 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.