1996 Mitsubishi Eclipse Chaned Water Pump On Had Set Timing Belt Got Running Now

1996 MITSUBISHI ECLIPSE
157,000 MILES
Avatar
CORY20SHELL
  • MEMBER
  • 7 POSTS
i changed the water pump on a 96 Eclipse and had to set the timing belt. got it running and now when I start the car it revs to about 3500rpms then goes to idle 1000 rpms then when shifting into any gear after pushing on the clutch to shift it spi
Feb 29, 2012 at 4:07 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ✓Experienced Mechanic
  • 110,240 POSTS
Make sure the timing is correct. Make sure there are no vacuum leaks. Make sure the IAC is okay
Feb 29, 2012 at 4:19 PM
Avatar
RASMATAZ
  • ✓Experienced Mechanic
  • 75,992 POSTS
Recheck the valve and ignition timing if okay-look for vacuum leak and misrouted vacuum line
Feb 29, 2012 at 4:20 PM
Avatar
CORY20SHELL
  • MEMBER
  • 7 POSTS
There are two vaccum lines that dont run to anything but there not blowing out or sucking in. But it ran fine befor removing the timing chain but it runs fine other than it reving up when u go to shift or start it
Feb 29, 2012 at 5:22 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.