i have a 1996 mazda protege and my airbag light is blinking in a sequences of seven can you tell me why this is and how to fix it please
Nov 5, 2012 at 5:36 AM
1996 MAZDA PROTEGE
ANONYMOUS
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
CODE 7 Passenger-Side Air Bag Module Circuit
CODE 7
NOTE:For connector terminal identification, see WIRING DIAGRAM .
Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Inspect passenger-side air bag module connectors for damage. If connectors are okay, go to next step. If connectors are damaged, replace passenger-side air bag module. Perform SYSTEM OPERATION CHECK .
Connect a 2 ohm resistor across terminals of passenger-side air bag module harness connector. Turn ignition switch ON and check for codes. If CODE 7 is displayed, go to next step. If CODE 7 is not present, replace passenger-side air bag module. Perform SYSTEM OPERATION CHECK .
Turn ignition switch to LOCK position. Replace SAS unit. Turn ignition switch ON and check for codes. If CODE 7 is still present, replace wiring harness. Perform SYSTEM OPERATION CHECK .
NOTE: Codes are automatically cleared when fault is corrected.
CODE 7
NOTE:For connector terminal identification, see WIRING DIAGRAM .
Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Inspect passenger-side air bag module connectors for damage. If connectors are okay, go to next step. If connectors are damaged, replace passenger-side air bag module. Perform SYSTEM OPERATION CHECK .
Connect a 2 ohm resistor across terminals of passenger-side air bag module harness connector. Turn ignition switch ON and check for codes. If CODE 7 is displayed, go to next step. If CODE 7 is not present, replace passenger-side air bag module. Perform SYSTEM OPERATION CHECK .
Turn ignition switch to LOCK position. Replace SAS unit. Turn ignition switch ON and check for codes. If CODE 7 is still present, replace wiring harness. Perform SYSTEM OPERATION CHECK .
NOTE: Codes are automatically cleared when fault is corrected.
Image (Click to enlarge)
Nov 5, 2012 at 5:59 AM
Advertisement