1996 Mazda B2300 change turn single switch

DOPEHEAD74

MEMBER
1996 MAZDA B2300
250,000 MILES

I am wanting to change the turn single switch on my truck but im really not sure what to do the switch also has the windshield wipers on it. It also has a drivers side air bag what tools will I need to do this job I could use all the advice u could give me. Thank you

1 Reply

TY ANDERSON

MECHANIC
719 POSTS

Disconnect negative battery cable. Deactivate air bag system before performing any service operation. By disconnecting the negative and then positive battery cables. Cover the battery terminal so the cables doesn't touch the battery terminals once removed. Wait at lease one minute before proceeding to remove signal switch. Steer the wheel straight ahead. Remove the driver air bag retaining nuts (on the side of the steering wheel). Disconnect the wiring to the air bag assembly. Disconnect any cruise control switch wiring if applicable. Mark the steering wheel retaining nut (marking the nut that holds the steering wheel) so the steering wheel will go back on the same way it came off. You may need a special tool to remove the steering wheel
from the steering shaft. Remove steering column upper and lower covers. Disconnect combination switch electrical connectors. Remove turn signal switch screws. Remove turn signal switch. Let me know if you have any questions.