cam position sensor Jeep

1996 JEEP CHEROKEE
100,000 MILES • 6 CYL • 4WD • AUTOMATIC
Avatar
CHARLESDYER
  • MEMBER
  • 1 POST
How to change cam position sensor jeep 1996 cherokee 6 cylinder
Dec 22, 2010 at 1:02 AM
Advertisement
Avatar
SATURNTECH9
  • ✓ASE Certified Mechanic
  • 30,869 POSTS
  • ASE Certified Mechanic
REMOVAL

1. Disconnect negative battery cable.
2. Remove distributor cap.
3. Disconnect electrical connector at camshaft position sensor.

NOTE: DO NOT pull on sensor electrical lead.

4. Remove distributor rotor.
5. Lift camshaft position sensor off distributor housing.

INSTALLATION

1. Install camshaft position sensor on distributor housing.
2. Install distributor rotor.
3. Connect electrical connector at camshaft position sensor.
4. Install distributor cap.
5. Connect negative battery cable.
Sep 29, 2020 at 11:11 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.