1996 Honda Accord Car Repair

1996 HONDA ACCORD
4 CYL • FWD • AUTOMATIC
Avatar
PSYCHO15068
  • MEMBER
  • 1 POST
I need to replace the studs on a 1996 Honda Accord and the knuckle will not move, is the knuckle staked?
Nov 30, 2010 at 2:15 PM
Advertisement
Avatar
KHLOW2008
  • ✓Experienced Mechanic
  • 41,814 POSTS
The hub is press fitted onto the wheel bearings and is secured by the CV joint central nut. After removal of the nut you need a hpuller to pull the hub out.
Dec 2, 2010 at 7:22 AM
Avatar
CHARLESCARVER
  • MEMBER
  • 1 POST
Ok I have just about the same problem where is this nut you speek of located?Is it behind the whole wheel asslebmly?
Dec 30, 2012 at 11:14 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.