Popping sound

1996 FORD TAURUS
6 CYL • FWD • AUTOMATIC
Avatar
JMBSTM
  • MEMBER
  • 1 POST
What is making popping sound in front end (while turning) on my 96 Ford Taurus? I have already changed cv axle, ball joint, bearing, strut, and tie rod end.
Nov 15, 2010 at 4:59 PM
Advertisement
Avatar
MONDEO MECHANIC
  • MEMBER
  • 4 POSTS
try changing the full drive shaft, it could be damaged where it fits into the g box
Nov 15, 2010 at 5:29 PM
Avatar
FORMERTECH
  • MEMBER
  • 4 POSTS
There is a flat bearing on top of the strut on many car models that the strut swivels on as you turn. I have seen them make quite a bit of noise. They don't always get replaced when changing a strut because they usually don't come with the new strut. One more suggestion, chech the lower control arm bushing where it bolts to the unibody. If it's worn or the bolt is loose it could make noise.
Nov 15, 2010 at 7:03 PM
Avatar
MHPAUTOS
  • ✓Experienced Mechanic
  • 31,937 POSTS
I would be checking the CV's first, faulty top strut bearings normally don't make this noise.

mhpautos
Nov 15, 2010 at 9:41 PM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Ask a new question

Frequently Asked Problems for This Vehicle