Advertisement

1996 Ford Ranger hard start

180,000 MILES • 2.3L • 4 CYL • 2WD • MANUAL
Avatar
JRAMOS322
  • MEMBER
  • 2 POSTS
I have a 4 cylinder 8 plug manuel 1996 ford ranger that will start of trouble free, first thing in the morning, in any weather. However, when I take of, and come to a stop and I am idle for about a minute it will start to shake like it wants to stall but it will stay on. Once I turn it off it will require that I press the gas pedal about 3/4 of the way down and crank it for about 15 seconds before it will start. In weather below 50 degree the problem is worse. I have to leave it sittin for over 4 hours so it can start with out hesitation. I have cleaned the mass air flow sensor and the idle air control . Any ideas what else I can do?
Jan 18, 2015 at 12:41 PM
Advertisement
Avatar
SATURNTECH9
  • ✓Experienced Mechanic
  • 30,869 POSTS
Have you checked the coolant temp sensor yet? Also have you checked for codes in the computer yet?
Jan 18, 2015 at 1:15 PM
Advertisement
Avatar
JRAMOS322
  • MEMBER
  • 2 POSTS
OReilly auto parts and advance auto parts have not been able to pull any codes. Haven't checked the coolent sensor. Will check after work today what part of the engine will I find it?
Jan 19, 2015 at 12:10 AM
Avatar
SATURNTECH9
  • ✓Experienced Mechanic
  • 30,869 POSTS
Its on the left rear of the engine below the oil pressure sending unit.
Jan 19, 2015 at 12:00 PM
Advertisement
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle