1996 FORD PROBE
175,000 MILES
Avatar
USKOWALSS
  • MEMBER
  • 1 POST
Trying to replace the alternator. I have it disconnected but I can not get it to go
between the transaxle and the rack and pinion to get it out from the engine. Most info says to remove the
crossmemeber, but I'm not even down to that point.
Feb 6, 2013 at 6:18 PM
Advertisement
Avatar
JDL
  • CERTIFIED EXPERT
  • 16,098 POSTS
I can give you info from our database.
Disconnect the battery ground cable.
Remove the generator upper bolt.
Loosen the generator adjusting arm.
Remove the drive belt from the generator.
Raise and support the vehicle.
Remove the six bolts from crossmember and remove crossmember. this will allow access to the generators electrical connectors and generator lower through bolt.
Disconnect the electrical connectors from the generator.
Remove the generator lower through bolt.
Remove generator from the vehicle.

Are you trying to take it out close to small part of halfshaft? My only problem is I can't see much from here? If steering linkage is in the way, have you tried turning the wheels in or out, to get more room.
Feb 7, 2013 at 3:58 PM