Fuel Gauge Inconsistencies

1996 FORD PROBE
88,000 MILES • 6 CYL • FWD • AUTOMATIC
Avatar
LRYMCD
  • MEMBER
  • 6 POSTS
1996 Ford Probe GT.

Inconsistent fuel gauge readings especially after making turns and stops. More noticeable after 1/2 tank. The gauge will go done and after driving will move back up a bit.

Consumer guide states: "The fuel gauge may read 3/4 full when the tank is full because of the fuel line return is bent and interferes with the sender in the tank".

Sometimes during a cold start, the engine idles a bit rough with slight sputtering, then it idles smoothly.

Things I've done:

• Changed spark plugs (gaped) and distributor cap - runs better

• changed fuel filter

• Replaced boost sensor - ran better

• Got a code for the MAF unit (Mass Air Flow). I cleaned it. It ran better but got code again after 150 miles.

• Added fuel system cleaner for a long trip.
May 20, 2011 at 7:32 AM
Advertisement
Avatar
RASMATAZ
  • CERTIFIED EXPERT
  • 75,992 POSTS
Sounds like you need to check and test the fuel sending unit/also the wiring
May 20, 2011 at 9:37 AM
Avatar
CJ MEDEVAC
  • CERTIFIED EXPERT
  • 11,004 POSTS
WHAT CODE DID YOU GET FOR THE MAF (RAZ THIS MIGHT BE YOU!) NOT CHANGIN' THE AIR FILTER....WOULD THAT MAYBE MESS WITH THE MAF?--OR AFTER THE 1ST TIME CLEANING, CLEAN AGAIN OR REPLACE IT?

I did check on a new MAF, that puppy ain't real cheap, at least you could get the core back.......You might take a "chance" at a Auto Salvage Yard, at the "Self Serve" type, things like that are $5-$10
Install one of these on your rig.....You will never be without fuel!

I never worry! I have made a few $$$, pulling them off, to gas up other folks stranded on the road! I always have lawnmower fuel!

The Medic
Images (Click to enlarge)
Attached Media
Attached Media
May 20, 2011 at 2:24 PM
Advertisement