1996 Ford Bronco hesitation on acceleration

1996 FORD BRONCO
5.8L • V8 • 4WD • AUTOMATIC
Avatar
JILLA
  • MEMBER
  • 46 POSTS
I recently changed wires, plugs, cap, rotor, ignition coil, dpfe sensor and my truck is still hesitating on acceleration. I really need help with this, another i notice i dont have a map sensor either. Someone please help me...
Dec 2, 2014 at 7:16 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
HMAC300
  • CAR REPAIR CONTRIBUTOR
  • 48,601 POSTS
scan for codes and check fuel pressure first with a gauge. auto parts rents it. yes you don't have amap sensor it may be called the dpfe sensor instead or it's with some thing else.
Dec 2, 2014 at 7:41 AM
Advertisement
Avatar
JILLA
  • MEMBER
  • 46 POSTS
I have no check engine light on. And i did change the dpfe sensor and it runs better at idle but in gear trying to accelerate it hesitates and shakes really bad
Dec 2, 2014 at 8:47 AM
Avatar
JOHNNYT73
  • CAR REPAIR CONTRIBUTOR
  • 924 POSTS
Check fuel pressure as he stated. Could be fuel filter or pump issue. Also check fuel pressure regulator. Pull off the vacuum hose going to the regulator and see if you see raw fuel coming out of it. If there is then replace it. Could also be a clogged converter.
Dec 2, 2014 at 9:04 AM