The motor and regulator assembly has to be replaced as a unit.
REMOVAL
1.Remove door trim panel and water shield.
2.Remove door glass retaining clips and allow glass to rest on bottom of door.
3.If equipped, disengage wire connector from power window motor.
Front Door Glass Window Lift Guides
4.Loosen screws holding front and rear window lift guides to inner door panel.
5.Separate screw heads on lift guides from key hole slots in inner door panel.
6.Loosen screws holding regulator to inner door panel.
7.Remove regulator from inner door panel.
Front Door Window Regulator
8.Extract rear lift guide through inner door panel access hole.
9.Extract front lift guide through access hole.
INSTALLATION
1.Insert front lift guide through access hole.
Front Door Window Regulator
2.Insert rear lift guide through access hole.
3.Place window regulator in position on inner door panel.
4.Place screw heads on guide rails in position through key hole slots in inner door panel.
5.Tighten screws to hold regulator to inner door panel.
6.Place screw heads on lift guides in position through key hole slots in inner door panel.
Front Door Glass Window Lift Guides
7.Tighten screws to hold front and rear window lift guides to inner door panel.
8.If equipped, engage wire connector into power window motor.
9.Install door glass.
10.Verify door glass alignment and operation.
11.Install water shield and door trim panel.
© 2013 ALLDATA LLC. All rights reserved. Terms and Conditions
It is not as easy job. It is tricky, be carefull not to break the window.
Roy
Jun 28, 2013 at 8:46 PM
