how to install a radiator on a 1996 chrysler sebring
Feb 16, 2011 at 8:03 AM
radiator replacement
SHEARER330
- MEMBER
- 1 POST
1.Disconnect battery ground cable and remove air inlet resonator.
2.Drain coolant into a suitable container.
3.Remove upper radiator crossmember.
4.Remove hose clamps and hoses from radiator.
5.Disconnect engine block heater electrical wire, if equipped.
6.Disconnect and plug automatic transaxle hoses at cooler.
7.Disconnect fan electrical connector.
8.Remove air conditioning condenser attaching screws located at front of radiator, if equipped. Do not discharge air conditioning system.
9.Remove radiator from engine compartment by lifting upward.
10.Reverse procedure to install.
2.Drain coolant into a suitable container.
3.Remove upper radiator crossmember.
4.Remove hose clamps and hoses from radiator.
5.Disconnect engine block heater electrical wire, if equipped.
6.Disconnect and plug automatic transaxle hoses at cooler.
7.Disconnect fan electrical connector.
8.Remove air conditioning condenser attaching screws located at front of radiator, if equipped. Do not discharge air conditioning system.
9.Remove radiator from engine compartment by lifting upward.
10.Reverse procedure to install.
Mar 9, 2011 at 7:27 PM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement
parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.