how to install a radiator on a 1996 chrysler sebring
Feb 16, 2011 at 4:03 PM
radiator replacement
1996 CHRYSLER SEBRING
SHEARER330
- MEMBER
- 1 POST
- FOLLOW
Advertisement
1.Disconnect battery ground cable and remove air inlet resonator.
2.Drain coolant into a suitable container.
3.Remove upper radiator crossmember.
4.Remove hose clamps and hoses from radiator.
5.Disconnect engine block heater electrical wire, if equipped.
6.Disconnect and plug automatic transaxle hoses at cooler.
7.Disconnect fan electrical connector.
8.Remove air conditioning condenser attaching screws located at front of radiator, if equipped. Do not discharge air conditioning system.
9.Remove radiator from engine compartment by lifting upward.
10.Reverse procedure to install.
2.Drain coolant into a suitable container.
3.Remove upper radiator crossmember.
4.Remove hose clamps and hoses from radiator.
5.Disconnect engine block heater electrical wire, if equipped.
6.Disconnect and plug automatic transaxle hoses at cooler.
7.Disconnect fan electrical connector.
8.Remove air conditioning condenser attaching screws located at front of radiator, if equipped. Do not discharge air conditioning system.
9.Remove radiator from engine compartment by lifting upward.
10.Reverse procedure to install.
Mar 10, 2011 at 3:27 AM