1996 CHRYSLER SEBRING
96,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
what to do when heater functoin control dont work
Mar 10, 2013 at 2:31 PM
Advertisement
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
check fuses and wnd what exactly is it doing? no heat?defrost?
Mar 10, 2013 at 3:23 PM
Avatar
MDVIOLETTE
  • MEMBER
  • 7 POSTS
cant switch it from defrost. blower works fine.
Mar 10, 2013 at 8:11 PM
Advertisement
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
check for a broken cable that has an arrow to it in pic attached.
Mar 10, 2013 at 8:14 PM
Avatar
MDVIOLETTE
  • MEMBER
  • 7 POSTS
there are no cables. uses voltage to change
Mar 10, 2013 at 8:19 PM
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
everything for a 96& 97 sebring shows cables and nothing else. are you sure it's the right car?
Mar 10, 2013 at 8:24 PM
Avatar
MDVIOLETTE
  • MEMBER
  • 7 POSTS
its the convertible. 96 sebring jx
Mar 10, 2013 at 8:27 PM
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
ok check the actuator and linkage where i have pointed out on drawing. see if it's getting power or not but before you do that try pulling HVAC fuse for 60 seconds with key on then reinstalling and waiting another minute. that sometimes resets that actuator to work again. if it's getting power then you need a new actuator or blend door is broken i coldn't get all of the pic in tosend.
Mar 10, 2013 at 9:47 PM
Avatar
MDVIOLETTE
  • MEMBER
  • 7 POSTS
I found the problem. My battery was weak and held less than 12 volts which sent faulty readings to bcm. replaced battery and all is fine. thanks for trying
Mar 29, 2013 at 12:59 AM