what to do when heater functoin control dont work
Mar 10, 2013 at 2:31 PM
1996 Chrysler Sebring Heater Functoin Control Work
1996 CHRYSLER SEBRING
ANONYMOUS
- MEMBER
- 1 POST
Advertisement
HMAC300
- ✓ASE Certified Mechanic
- 48,601 POSTS
check fuses and wnd what exactly is it doing? no heat?defrost?
Mar 10, 2013 at 3:23 PM
cant switch it from defrost. blower works fine.
Mar 10, 2013 at 8:11 PM
HMAC300
- ✓ASE Certified Mechanic
- 48,601 POSTS
check for a broken cable that has an arrow to it in pic attached.
Image (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Click here to log in and view diagram.
Mar 10, 2013 at 8:14 PM
there are no cables. uses voltage to change
Mar 10, 2013 at 8:19 PM
HMAC300
- ✓ASE Certified Mechanic
- 48,601 POSTS
everything for a 96& 97 sebring shows cables and nothing else. are you sure it's the right car?
Mar 10, 2013 at 8:24 PM
its the convertible. 96 sebring jx
Mar 10, 2013 at 8:27 PM
HMAC300
- ✓ASE Certified Mechanic
- 48,601 POSTS
ok check the actuator and linkage where i have pointed out on drawing. see if it's getting power or not but before you do that try pulling HVAC fuse for 60 seconds with key on then reinstalling and waiting another minute. that sometimes resets that actuator to work again. if it's getting power then you need a new actuator or blend door is broken i coldn't get all of the pic in tosend.
Image (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Click here to log in and view diagram.
Mar 10, 2013 at 9:47 PM
I found the problem. My battery was weak and held less than 12 volts which sent faulty readings to bcm. replaced battery and all is fine. thanks for trying
Mar 29, 2013 at 12:59 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.