1996 Chrysler LHS itermittant down shift with transmission

1996 CHRYSLER LHS
250,000 MILES • 3.5L • V6 • 2WD • AUTOMATIC
Avatar
ALEXANDERCOSTAL
  • MEMBER
  • 3 POSTS
96 lhs automatic transmission will down shift hard at about 45mph and wont shift back up into higher gear while car is still moving down road unless while still moving I put in neutral cut ignition off then restart and shift back into drive it takes the higher gear until I slow down again or stop. Problem is intermitant as it doesn't do it everytime I drive the car.had transmission flushed some improvement in operation but problem still persists now and then. Was wondering what can be done to fix this problem?
Dec 17, 2014 at 10:04 AM
Advertisement
Avatar
CARADIODOC
  • ✓Experienced Mechanic
  • 34,367 POSTS
Defaulting to second gear is "limp mode" which allows you to drive slowly to a repair shop without needing a tow truck. You already know that you get it out of limp mode by turning off the ignition switch and restarting the engine. When this occurs, it is in response to the Transmission Computer detecting a problem. In this case it is most likely to be related to one of the speed sensors, but to know for sure, the place to start is always by having the diagnostic fault code(s) read. Fault codes never say to replace a part or that one is bad. They will indicate the circuit that needs further diagnosis or the unacceptable operating condition.
Dec 17, 2014 at 10:13 AM
Avatar
ALEXANDERCOSTAL
  • MEMBER
  • 3 POSTS
Thanks I have some experience at working on vehicles in a dealership environment and a few shops over the years. I was thinking the same thing earlier today about the speed sensor causing the problem but needed an opinion from someone who has more experience with this type of issue. I will pull the codes and see if suspicions are correct and go from there . My own vehicle and don't want to replace parts blindly without understanding why its happening. Always learning something different. Thanks Again
Dec 17, 2014 at 10:50 AM
Avatar
ALEXANDERCOSTAL
  • MEMBER
  • 3 POSTS
. pulled codes low speed fan circuit, multiple cylinder misfire detected, and cylinder 5 misfire detected 3 codes in all but nothing pertaining to transmission trouble unless I need a different setup to pull codes for transmission.
Dec 17, 2014 at 11:29 AM
Avatar
CARADIODOC
  • ✓Experienced Mechanic
  • 34,367 POSTS
Yup. You're in the Engine Computer. You need a scanner that can access the Transmission Computer. It is usually referred to as the "EATX". Electronic automatic transmission controller.
Dec 18, 2014 at 1:13 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.