1996 K1500 No power to computer, coil, fuel pump, guage pack.

1996 CHEVROLET TRUCK
235,000 MILES
Avatar
SKIP ROCK
  • MEMBER
  • 2 POSTS
Cranks over but will not start. Fuses all good both inside of truck and under hood. Checked for voltage to fuse block under hood - yes. Checked voltage to fuses pertaining to starting, all had voltage except ECM-1 with key turned on. Could it be a fuseable link between starter and switch ?
Sep 30, 2011 at 4:45 PM
Advertisement
Avatar
ASEMASTER6371
  • ✓ASE Certified Mechanic
  • 52,796 POSTS
  • ASE Certified Mechanic
you need to re check your fuses and use a test light to verify power on both sides. check the fusible links at the starter as well.
no matter what or which fuse is blown, this is just the beginning. you must find out the reason for this failure or it will continue to fail.

Roy
Sep 30, 2011 at 4:54 PM
Avatar
DOCFIXIT
  • ✓ASE Certified Mechanic
  • 18,828 POSTS
  • ASE Certified Mechanic
Powered of ignition switch
Sep 30, 2011 at 4:57 PM
Avatar
SKIP ROCK
  • MEMBER
  • 2 POSTS
Where would the fuseable links be located at after the starter ?
Sep 30, 2011 at 5:08 PM
Avatar
JACOBANDNICKOLAS
  • ✓ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
There is a fuseable link that goes from the batter to the alternator, not the starter. I have attached wiring schematics of both the charging system and starting system. I hope they help.
Images (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Oct 1, 2011 at 1:50 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.