4+4

1996 CHEVROLET S-10
4 CYL • 4WD • AUTOMATIC
Avatar
MRFIXITKING
  • MEMBER
  • 1 POST
1998 S10 BLASER WONT COME OUT OF FOUR WHEEL DRIVE REPLACED THE ENCODER AND 4+4 SWITCH NOTHING .pUT IN A DIFFERNT TRANSFERCASE DOSE THE SAME THING IT WILL GO IN FOUR LOW AND HIGH BUT WILL NOT GO IN TWO WHEEL DRIVE HELP
Dec 13, 2010 at 4:01 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ✓Experienced Mechanic
  • 110,240 POSTS
It sounds like something could be sticking in the front differential. Have you checked that? Also, have you checked for vacuum leaks? Is the linkage properly adjusted to the transfer case? If you have an electric shift 4wd, are you sure the actuator is getting power when you request 2wd? ti may be your t-case module . that is located in the kick panel on the passenger side. make sure to check any fuses and relays as well.
Dec 17, 2010 at 8:32 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.