1996 Corsica does not stay running until it is warmed up?
Dec 1, 2010 at 10:54 PM
Sensor I have been told. Need to know which one.
1996 CHEVROLET CORSICA
NANCYB3US
- MEMBER
- 1 POST
Advertisement
DR LOOT
- ✓ASE Certified Mechanic
- 2,311 POSTS
IDLE CONTROL SYSTEM (C-2)
IDLE AIR CONTROL (IAC) MOTOR
Disconnect harness connector to motor. Check resistance across IAC coil terminals "A" and "B" (coil "B") and "C" and "D" (coil "A"). See Fig. 5 . Resistance should be 40-80 ohms. If resistance is as specified, go to next step. If resistance is not as specified, replace IAC motor.
Check resistance between IAC terminals "B" to "C" and "A" to "D". Resistance should be infinite. If resistance is not as specified, replace IAC motor.
NOTE:Additional testing of Idle Air Control (IAC) motor requires an IAC motor actuator and noid light, or a scan tool capable of cycling PCM output devices (General Motors Tech 1).
Fig. 5: IAC Motor Circuit (Typical)
Courtesy of GENERAL MOTORS CORP.
IDLE AIR CONTROL (IAC) MOTOR
Disconnect harness connector to motor. Check resistance across IAC coil terminals "A" and "B" (coil "B") and "C" and "D" (coil "A"). See Fig. 5 . Resistance should be 40-80 ohms. If resistance is as specified, go to next step. If resistance is not as specified, replace IAC motor.
Check resistance between IAC terminals "B" to "C" and "A" to "D". Resistance should be infinite. If resistance is not as specified, replace IAC motor.
NOTE:Additional testing of Idle Air Control (IAC) motor requires an IAC motor actuator and noid light, or a scan tool capable of cycling PCM output devices (General Motors Tech 1).
Fig. 5: IAC Motor Circuit (Typical)
Courtesy of GENERAL MOTORS CORP.
Image (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Click here to log in and view diagram.
Dec 2, 2010 at 6:15 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.