troubleshooting

1996 CHEVROLET ASTRO
245,000 MILES • 6 CYL • 2WD • AUTOMATIC
Avatar
SONOMA
  • MEMBER
  • 2 POSTS
im working on a 1996 astro van 4.3L it has a misfire on cyl 6 i have done everything i could think i did compression test, plugs,wires, cap,rotor,cam sensor,cyl balance test,checked intake for leaks,also tryed coil,fuel pressure test,
Feb 1, 2011 at 3:14 AM
Advertisement
Avatar
OBXAUTOMEDIC
  • ASE Certified Mechanic
  • 3,711 POSTS
  • ASE Certified Mechanic
Hello,

Ok, on that year the Spider Assembly has been known to fail, and of course you have to replace the hole assembly. Pics of assembly below...

Feb 1, 2011 at 3:26 AM
Avatar
SONOMA
  • MEMBER
  • 2 POSTS
i checked the spider it is fine i put fuel pressure tester on it did bleed down. any other ideas?
Feb 1, 2011 at 3:55 AM
Avatar
OBXAUTOMEDIC
  • ASE Certified Mechanic
  • 3,711 POSTS
  • ASE Certified Mechanic
Ok, you stated that it "Did Bleed Down" if this is correct then you could have a leaky Injector.

When you changed the Plugs did you make note of what condition each plug was in. If still have plugs check out link below for spark conditions..... Scroll down the page....

https://www.2carpros.com/articles/how-to-change-spark-plugs

.
Feb 1, 2011 at 1:31 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.