1996 Cadillac Deville. How do you replace the power steering pump?
Apr 14, 2011 at 11:00 PM
bad pump
1996 CADILLAC DEVILLE
ANDYLORGE2000
- MEMBER
- 1 POST
Advertisement
SATURNTECH9
- ✓ASE Certified Mechanic
- 30,869 POSTS
REMOVE OR DISCONNECT
Serpentine belt.
Power steering fluid from reservoir.
Return pipe from reservoir.
Pressure pipe from pump.
Pump mounting bolt.
Remove pump, reservoir, pulley and bracket assembly from vehicle.
Pump and reservoir from bracket.
Retaining clips that attach reservoir to pump.
Pulley from pump with special tool J 38825.
INSTALL OR CONNECT
Pulley to pump with special tool J 25033-B.
IMPORTANT
Face of pulley hub is not flush with pump drive shaft. Install pulley until an internal stop is contacted.
Do not use arbor press to install pulley.
Retaining clips that attach reservoir to pump.
Pump and reservoir to bracket. Tighten pump to bracket bolts to 24 Nm (18 ft-lb.).
Position pump, reservoir, pulley and bracket assembly into vehicle.
Pump mounting bolt to engine. Tighten pump mounting bolt to 47 Nm (35 ft-lb.).
Pressure pipe to pump. Tighten pressure pipe fitting to 27 Nm (20 ft-lb.).
Return hose to reservoir.
Serpentine belt.
Fill and bleed power steering system.
Serpentine belt.
Power steering fluid from reservoir.
Return pipe from reservoir.
Pressure pipe from pump.
Pump mounting bolt.
Remove pump, reservoir, pulley and bracket assembly from vehicle.
Pump and reservoir from bracket.
Retaining clips that attach reservoir to pump.
Pulley from pump with special tool J 38825.
INSTALL OR CONNECT
Pulley to pump with special tool J 25033-B.
IMPORTANT
Face of pulley hub is not flush with pump drive shaft. Install pulley until an internal stop is contacted.
Do not use arbor press to install pulley.
Retaining clips that attach reservoir to pump.
Pump and reservoir to bracket. Tighten pump to bracket bolts to 24 Nm (18 ft-lb.).
Position pump, reservoir, pulley and bracket assembly into vehicle.
Pump mounting bolt to engine. Tighten pump mounting bolt to 47 Nm (35 ft-lb.).
Pressure pipe to pump. Tighten pressure pipe fitting to 27 Nm (20 ft-lb.).
Return hose to reservoir.
Serpentine belt.
Fill and bleed power steering system.
Apr 15, 2011 at 12:21 AM
CADIEMAN
- ✓ASE Certified Mechanic
- 3,544 POSTS
if its leaking u need to find it first
Apr 15, 2011 at 4:59 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.