tensioner pulley problem 96 skylark

1996 BUICK SKYLARK
60,000 MILES • 6 CYL • FWD • AUTOMATIC
Avatar
CJPA32
  • MEMBER
  • 3 POSTS
1996 buick skylark custom 3.1 v6
how do i replace the tensioner pulley, i know the basic "bolt it on" but is a very tight space i can not get a serp tool into. The old one busted off and i cant even pull it out because the space is too tight. Any help would be greatly appreciated.
Aug 18, 2011 at 5:40 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
MERLIN2021
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 17,250 POSTS
Jack engine up un that side might need to remove mount might not. use a piece of wood and a floor jack.
Aug 18, 2011 at 5:54 PM
Advertisement
Avatar
CJPA32
  • MEMBER
  • 3 POSTS
Strut tower is in the way, id have to go up about 6-8 inches. Would this mean other disconnections so as not to damage anything
Aug 19, 2011 at 6:06 PM
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
You may have to disconnect a few things. Lift the engine slowly so you can watch if anything needs disconnected.
Oct 6, 2011 at 11:11 AM