Difficulty in acceleration after replacing plugs and wires from a misfiring issue

All you needed was the wire. Remove the number six wire at the coil. The engine should bog down when you remove the wire at the coil. Then when you reconnect it is to pick back up. Repeat this with all the wires. You should have the same results. Then come back.

How do you know it's a number six wire misfiring? Try swapping number six wire with another one and see if it changes any.

We need to find out for sure that this is still misfiring on cylinder 6. We can do that by checking codes. Then if you have a scan tool then you need to monitor the injector pulse width to ensure it is the same as the others. If the cylinder is misfiring the PCM should be altering the pulse width to try and compensate for the misfire.

At that point, I would swap that injector with one from the other bank and see if the misfire moves to that cylinder. If it does then you know that injector is the issue. If not, we need to keep digging. However, I suspect that is the issue assuming the misfire is still on the same cylinder.

I attached the process on how to replace the injectors so let's confirm what cylinder is misfiring and swap the injector. Let me know what you find. Thanks