Serpentine belt came off. Looking at the diagram for putting the belt back on I am missing the tensioner. It must have broke off.
May 25, 2012 at 12:51 PM
how do you replace a drive belt tensioner assembly.Serpentine belt came
MRSDRAGON
- MEMBER
- 1 POST
Advertisement
did bolt break and still inbedded in block? or is part of tensioner assembly still there? unbolt and replace it.
May 25, 2012 at 1:37 PM
Have a look at the attached image... and this PDF:
http://fkh161.ca/Temp/beltaah.pdf
I assume you have a 2.8 V6
Thomas
http://fkh161.ca/Temp/beltaah.pdf
I assume you have a 2.8 V6
Thomas
Image (Click to enlarge)
May 26, 2012 at 4:31 PM
The tensioner is secured to the engine via bolt #11 (8mm allen).
On the back of the tensioner is a "locating dimple" which allows
for correct placement of the tensioner.
Thomas
On the back of the tensioner is a "locating dimple" which allows
for correct placement of the tensioner.
Thomas
May 26, 2012 at 4:40 PM
Actually, it might even be a 10mm allen head bolt... it's been a
while since I had to remove one.
Thomas
while since I had to remove one.
Thomas
May 26, 2012 at 4:54 PM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement
parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.