Here are the diagnostic procedures. Disregard those that are not relevant.
CRUISE CONTROL CANNOT BE SET
Test main switch.
Test SET/RESUME switch.
Test brakelight switch and mounting.
Test gearshift lever position switch.
Check cruise control unit inputs.
Check ground connection G301, located in left side of engine compartment next to windshield washer fluid reservoir.
Check ground connection G201, located at right front side of engine compartment.
Check ground connection G401, located behind left kick panel.
Check the following wires for opens or loose and/or disconnected terminals.
Repair wires as necessary and recheck system operation.
Check Blue/Green wire between horn relay and clockspring.
Check Light Green/Red wire between cruise control unit and clockspring.
Check Blue wire between cruise control unit and Ignition Control Module (ICM). Check Black/Yellow wire between cruise control unit and fuse No. 24 (15-amp), located in fuse/relay box under instrument panel.
Check Light Green wire between cruise control unit and main switch.
Check Gray wire between cruise control unit and brake switch.
Check Orange wire between cruise control unit and Vehicle Speed Sensor
(VSS).
Check Brown/White wire between cruise control unit and actuator assembly.
Check Brown/Black wire between cruise control unit and actuator assembly.
Check Brown/Red wire between cruise control unit and actuator ssembly.
Check Pink wire between cruise control unit and gear position switch.
Page 1 of 1
CRUISE CONTROL SYSTEM -1996 Acura Integra LS
31/1/2011
SPONSORED LINKS
Sunday, January 30th, 2011 AT 4:05 PM