how do i replace the axle seal on the side of the transfer case on my 95 subaru legacy
Mar 30, 2013 at 2:37 PM
1995 Subaru Legacy Replace Axle Seal On Side Transfer Case 95
ANONYMOUS
- MEMBER
- 1 POST
Advertisement
Undo the drive shaft nut, this will be extremely tight, wheel off, tie rod end off, lower strut undone, swing strut away and pull drive shaft from hub, on the transmission end, the shaft is secured with a roll pin that must be driven out with a pin punch, then you can remove the shaft to access the seal, lever out seal and carefully tap in new seal and lube seal lip with light grease.
Mar 30, 2013 at 2:45 PM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement
parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.