Saab has no power after replacing ignition swtich

1995 SAAB 900
100 MILES • 4 CYL • FWD • MANUAL
Avatar
NKD1303
  • MEMBER
  • 1 POST
1995 Saab SE Turbo. Replaced ignition switch, still wont start. No power, no lights, no nothing.
Replaced it following this diagram.... http://photo.platonoff.com/Auto/20070617a.Saab_NG900_Shifter_Housing_Removal/?all
Jul 14, 2011 at 1:56 AM
Advertisement
Avatar
RASMATAZ
  • ✓ASE Certified Mechanic
  • 75,992 POSTS
  • ASE Certified Mechanic
Check and test maxi fuse no.3 60amp this is the one that powers the ignition switch
Jul 14, 2011 at 2:40 AM
Avatar
MNTHNY4
  • ✓ASE Certified Mechanic
  • 612 POSTS
  • ASE Certified Mechanic
u replaced the wrong part what u need is the module under your drivers seat mount to the floor under the carpet ,this module is called the [ICE module ] replace that and u r good to go ,good luck.note module will need programming to work properly ,u can also buy used from this place called goldwing saab ,check web for there contact info.
Jul 20, 2011 at 12:25 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.