1995 OLDSMOBILE DELTA 88
67,568 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
When replacing cylinder head gasket Are pushrods intake and exhaust all the same size If 2 rods get mixed up while installing them will It bend the valve


Feb 2, 2013 at 8:46 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
if you have a 3.8 you are good.

lay them all out together, they should all be the same length

Roy
Feb 2, 2013 at 9:05 PM
Advertisement
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
And make sure the push rods are not bent-roll it on top of a glass table if its wobbly replace it-Good day Mr. Roy
Feb 2, 2013 at 9:10 PM
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
good day my friend
Feb 2, 2013 at 9:19 PM