1995 Oldsmobile 98 no crank no start

1995 OLDSMOBILE 98
100,000 MILES • 3.8L • V6 • 2WD • AUTOMATIC
Avatar
NEDLOB
  • MEMBER
  • 24 POSTS
This olds will not crank when key is turned on. I was told by the owner that if you turn the ignition on and cross out the starter it will start and run. Tried putting resistor in line of VATS. Still won't crank. #6 vats key @1470 ohms. What's keeping it from cranking.
Oct 6, 2014 at 8:56 PM
Advertisement
Avatar
NEDLOB
  • MEMBER
  • 24 POSTS
starter checked by the big three pass two failed one something about terminal R. Which was loose.
Oct 6, 2014 at 9:27 PM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
When you turn the key to the run position is the security light on solid or flashing?
Oct 6, 2014 at 9:52 PM
Advertisement
Avatar
NEDLOB
  • MEMBER
  • 24 POSTS
it's solid then goes out.
Oct 6, 2014 at 10:13 PM
Avatar
NEDLOB
  • MEMBER
  • 24 POSTS
got court in a few hours better turn in pick this up later.
Oct 6, 2014 at 10:17 PM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
Doesn't sound like the security system is the problem then.Do you have a multi meter to do some testing?
Oct 7, 2014 at 5:59 AM
Avatar
NEDLOB
  • MEMBER
  • 24 POSTS
yes
Oct 7, 2014 at 9:38 AM
Avatar
NEDLOB
  • MEMBER
  • 24 POSTS
going to game will return after STL wins!






































Oct 7, 2014 at 11:35 AM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
Alright out of the ignition switch the yellow wire should have battery voltage with the key in the start position? All these tests will be with the key in the start position. Next find your ant theft relay behind left side of dash above the inside fuse box.The yellow wire should have battery voltage both of them?as well as the purple wire to it?the yellow wire with a black tracer should have ground to it?Then your neutral safety switch should have power to the yellow wire and the purple wire?Then at your starter there should be battery voltage on the purple wire?Remember all these tests with the key in the start position.
Oct 7, 2014 at 12:24 PM
Avatar
NEDLOB
  • MEMBER
  • 24 POSTS
ant theft relay is this the same as the starter enable relay. If so i check this and did not get any reading on anything both yellow wires purple wire nothing.
Oct 12, 2014 at 2:54 PM
Avatar
NEDLOB
  • MEMBER
  • 24 POSTS
this car is not at home it is several mile away, sorry for taking so long to get back with you.
Oct 12, 2014 at 2:57 PM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
Yes the anti theft relay should be the same . Do you get power out of the yellow wire from the ignition switch with the key in the start position?
Oct 12, 2014 at 3:14 PM
Avatar
NEDLOB
  • MEMBER
  • 24 POSTS
No. While checking with vom no reading out of either wire. This is one hard set of wire to get to!
Oct 12, 2014 at 5:20 PM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
So the yellow wire at the ignition switch with the key in the start position doesn't have battery voltage?
Oct 12, 2014 at 5:24 PM
Avatar
NEDLOB
  • MEMBER
  • 24 POSTS
No.
Oct 12, 2014 at 5:34 PM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
Alright the red wire to the ignition switch should have battery voltage all the time?If so looks like the ignition switch is bad.If the red wire doesnt have battery voltage to it then check the fuse number 2 in the underhood fuse box. Its a 60 amp fuse?
Oct 12, 2014 at 5:53 PM
Avatar
NEDLOB
  • MEMBER
  • 24 POSTS
Retested. Went back and rechecked wires @ starter enable relay, this time used test light and turned key to cranking position not just in on position, got light from one yellow wire and purple wires.
Oct 15, 2014 at 5:04 PM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
At the relay the purple wireshould have battery voltage. The yellow wire terminal c1 should have battery voltage with the key in the start position?the yellow wire terminal a2 should have battery voltage with the key in the start position? The yellow wire with a black stripe should have a ground to it with the key in the start position?
Oct 15, 2014 at 6:42 PM
Avatar
NEDLOB
  • MEMBER
  • 24 POSTS
Yellow turns on test light, purple as well get nothing from yellow wire on other side. Also can hear relay click.
Oct 15, 2014 at 9:37 PM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
Need to know the terminals that there is power and no power your my eyes and hand's.
Oct 15, 2014 at 9:53 PM
Avatar
NEDLOB
  • MEMBER
  • 24 POSTS
It seems as though c1 a yellow wire c2 the purple wire both test good I get nothing from a2.
Oct 16, 2014 at 9:40 AM
Avatar
NEDLOB
  • MEMBER
  • 24 POSTS
Check ignition fuse under hood it ok.
Oct 16, 2014 at 9:42 AM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
While cranking see if terminal a1 yellow wire with a black stripe is getting a ground?
Oct 16, 2014 at 1:19 PM
Avatar
NEDLOB
  • MEMBER
  • 24 POSTS
I get no reading from yellow/black wire with test light or vom. Maybe I am doing the test wrong. I retested all wires get 12.25 volts on both yellow and purple wires only when switch is in the crank position. With switch only in on position there is no voltage.
Oct 17, 2014 at 1:53 PM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
The yellow wire with a black stripe your looking for a ground not power on that wire while cranking.
Oct 19, 2014 at 8:36 AM
Avatar
NEDLOB
  • MEMBER
  • 24 POSTS
No voltage to yellow/black wire. Did recheck all wire 12 volt to purple wire while cranking 12 volt to both yellow wires no power to yellow/black. What I did see was while checking the wires with switch in crank position light come on with switch fully engaged the test light would go out???


Oct 19, 2014 at 6:01 PM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
Not sure what you mean by with switch fully engaged the test light goes out?Also for the third time the yellow wire with a black stripe should be a ground not a power.If your using a test light you would hook up the aligator clip on the test light to power.Then test the yellow wire with a black stripe the test light should light up with the key in the start position? .
Oct 19, 2014 at 6:08 PM
Avatar
NEDLOB
  • MEMBER
  • 24 POSTS
When I say fully engage that is the key is being held it the crank position and the test light comes on and then goes out.
Oct 19, 2014 at 7:33 PM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
So how is that ground doing?
Oct 20, 2014 at 8:42 PM
Avatar
NEDLOB
  • MEMBER
  • 24 POSTS
Thanks for your help changed neutral safty switch car started like new. Thank you so much!
Oct 31, 2014 at 4:14 PM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
Your welcome glad i could help.
Nov 22, 2014 at 4:20 PM