What do I do with the bolts from the outer chain guides?

Tiny
IMPORTTUNER
  • MEMBER
  • 1995 NISSAN ALTIMA
  • 4 CYL
  • FWD
  • AUTOMATIC
  • 175,000 MILES
. Do I leave them in or throw them out?
Thursday, December 29th, 2011 AT 12:52 PM

3 Replies

Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
If you got new bolts use it-don't use the old ones-that's if I understood you correctly
Was this
answer
helpful?
Yes
No
Thursday, December 29th, 2011 AT 1:02 PM
Tiny
IMPORTTUNER
  • MEMBER
  • 91 POSTS
I mean after I eliminate the two guides do I leave the bolts in or leave them out?
Was this
answer
helpful?
Yes
No
Thursday, December 29th, 2011 AT 1:10 PM
Tiny
WRENCHTECH
  • MECHANIC
  • 20,761 POSTS
If they go all the way through and seve a purpose, put them back in. If all they did is hold the guides, don't worry about them.
PS: in the future, make your responses to your original question so the whole story stays together. Nobody but me had any idea what the history here was.
Was this
answer
helpful?
Yes
No
Thursday, December 29th, 2011 AT 1:19 PM

Please login or register to post a reply.

Related Transmission Clutch Throw Out Bearing Content

Throwout Bearing - Secondary Cylinder Replacement
GUIDE
Throwout Bearing - Secondary Cylinder Replacement
A throwout bear­ing/​sec­ondary cylin­der is used to ap­ply force against the clutch pres­sure plate to re­lease the clutch disc and should be re­placed as part of the nor­mal clutch...
VIEW MORE