1995 Nissan 240SX fuel delievery problem

1995 NISSAN 240SX
145,000 MILES • 2.4L • 4 CYL • RWD • AUTOMATIC
Avatar
TTTONEY89
  • MEMBER
  • 2 POSTS
so I have a 240sx and two days ago I turned it on and drove it about 100 yards and it died.

I assumed it was out of gas (the fuel gauge does not work so I wasent sure.) after putting 5 gallons in and tried it, it still would not start.

I then checked and replaced the spark plugs with all new ones, but still nothing, so then I thought there might be a problem with the fuel not getting to the engine since I was able to confirm that there was a spark.

I bought engine starting fluid and sprayed it it into the intake (4 short sprays) then attempted to start it and it did. however it then died after about 15 seconds.

I also checked the fuse for the fuel pump and it is fine.

the car will crank just fine it just will not turn over unless I use starting fluid and then it wont stay running for more than a few seconds.

do you think that the fuel pump needs to be replaced or what else would it be??

Thanks

Travis
May 8, 2014 at 2:52 PM
Advertisement
Avatar
RASMATAZ
  • ASE Certified Mechanic
  • 75,992 POSTS
  • ASE Certified Mechanic
Sounds like you need to check the fuel pressure to rule out a failing fuel pump-start here
May 8, 2014 at 3:19 PM
Avatar
TTTONEY89
  • MEMBER
  • 2 POSTS
if there is no fuel pressure that points to the fuel pump since the relay is alright, correct?
May 8, 2014 at 3:21 PM
Avatar
RASMATAZ
  • ASE Certified Mechanic
  • 75,992 POSTS
  • ASE Certified Mechanic
No fuel pressure-means the fuel pump is gone
May 10, 2014 at 10:17 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.