1995 eclipse timing belt problems

150,000 MILES • 4 CYL • FWD • AUTOMATIC
Avatar
MORRIS32
  • MEMBER
  • 4 POSTS
I have tried to put on a timing belt 14 times. It is a 1995 Mitsubishi eclipse with the 2.0 non turbo. I due the 1/2 notch deal and then run belt. I think having trouble on cam alignment, because after i turn over by hand 2 times and a tdc the cams no longer line up. Help this is a project to long to still be going on.
Jun 7, 2011 at 9:29 AM
Advertisement
Avatar
DOCFIXIT
  • ✓Experienced Mechanic
  • 18,828 POSTS
Hydraulic or manual tensioner? on cam align marks so 609 stamped on gear face each other. Also did belt brake?
Jun 7, 2011 at 11:48 AM
Avatar
MORRIS32
  • MEMBER
  • 4 POSTS
the tensioner is the one you have to push back with vise. Good to know about 609 stamp Chilton book does not specify. Also the belt did not break I rebuilt motor for brother. I know old style with distributor and chain in front this was a new bear for me and a learning exp.I thought would be easy, boy was i wrong.
Jun 7, 2011 at 4:08 PM
Avatar
DOCFIXIT
  • ✓Experienced Mechanic
  • 18,828 POSTS
Tensioner compressed in vice and lock pin installed? Install belt in direction shown see diagram from crank up to cam get as tight as possible. Hole belt to cam gear with one of those paper clips with the movable tabs. If needed rotate cam gear clockwise slightly to ingage tooth on belt.when belt on use torque wrench apply 21 ft.lbs then slide tensioner up to contact tighten then remove lock pin. rotate 2X
Jun 8, 2011 at 6:42 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle

Advertisement