axles

1995 LEXUS ES
FWD • AUTOMATIC
Avatar
GETSMAKKED
  • MEMBER
  • 21 POSTS
Hi, i replaced front axle assembly and some gear fluid leaked? the job is complete, how and where do i fill gear oil, is that basic engine oil that i pour it in? or transmission fluid? looks like oil.
Dec 1, 2011 at 9:57 AM
Advertisement
Avatar
HMAC300
  • ✓Experienced Mechanic
  • 48,601 POSTS
howmuch leaked? if it was just avery small amount you probably don'tneed any but check it anyhow. picture enclosed. plug noted by red arrow
Image (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Dec 1, 2011 at 10:06 AM
Avatar
GETSMAKKED
  • MEMBER
  • 21 POSTS
About half a litre leaked I'm assuming. I would still like to add a bit though. But is it some special gear oil, or normal oil used for engine oil. Also, not really sure where this plug might be, I kind of understand the diagram, I know where the transmission dipstick is, is it near that?..
Dec 1, 2011 at 12:10 PM
Avatar
HMAC300
  • ✓Experienced Mechanic
  • 48,601 POSTS
you'll have to reach the plug from under the car.it says in our manual that DEXTRONII is what you use. it takes 0.9 qtor .9L
Dec 1, 2011 at 12:35 PM
Avatar
GETSMAKKED
  • MEMBER
  • 21 POSTS
Oh ok that helps. Last thing, Is that a dipstick next to that plug so I can check first if I need?..
Dec 1, 2011 at 12:47 PM
Avatar
HMAC300
  • ✓Experienced Mechanic
  • 48,601 POSTS
it's a plug not a dipstick, you need to use your finger to check it. if you can feel the oil then you are ok.
Dec 1, 2011 at 12:54 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.