1995 ES300 Exhaust Manifold

1995 LEXUS ES
Avatar
GETSMAKKED
  • MEMBER
  • 21 POSTS
Hi, I just purchased a R.H exhaust manifold for my 1995 ES300 along with the gasket (3layers welded together). My question is do I use a type of silicone on both sides for the gasket to sit in place and for a proper seal?
Dec 1, 2010 at 3:48 AM
Advertisement
Avatar
CARADIODOC
  • ✓ASE Certified Mechanic
  • 34,321 POSTS
  • ASE Certified Mechanic
No sealers are used on exhaust gaskets. The three layers will compress to fill any voids. A lot of engines don't even use gasket between the manifold and the engine.

caradiodoc
Dec 1, 2010 at 3:53 AM
Avatar
JACOBANDNICKOLAS
  • ✓ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
I don't recommend using any sealant. If the head and the manifold are true (not warped) the gasket will seal it fine. Just make sure to torque the nuts to 41 ft/lbs.
Dec 1, 2010 at 4:02 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.