calibrate ditributor kia sephia 1995
Jan 15, 2011 at 2:29 PM
kia sephia 1995
1995 KIA SEPHIA
LUAI HAMMED
- MEMBER
- 1 POST
Advertisement
IGNITION TIMING
1. Ensure engine is at normal operating temperature. Turn off all accessories. Connect a jumper wire between terminals GROUND and ENG TEST (Light Green/Yellow wire) of Data Link Connector (DLC). DLC is located in center rear of engine compartment, in front of bulkhead. See Fig. 1 .
2. Connect inductive timing light to No. 1 spark plug wire. Start engine and allow it to idle. Check ignition timing. Timing mark on crankshaft pulley and mark on timing belt cover should be aligned to.
3. If timing is not within specification, loosen distributor hold-down bolts and rotate distributor base to adjust. Recheck timing and tighten distributor hold-down bolts to 14-19 ft. lbs. (19-26 N.m).
BASE IGNITION TIMING
ApplicationDegrees @ Idle
1.6L9-11 BTDC
© 2008 Mitchell Repair Information Co., LLC.
1. Ensure engine is at normal operating temperature. Turn off all accessories. Connect a jumper wire between terminals GROUND and ENG TEST (Light Green/Yellow wire) of Data Link Connector (DLC). DLC is located in center rear of engine compartment, in front of bulkhead. See Fig. 1 .
2. Connect inductive timing light to No. 1 spark plug wire. Start engine and allow it to idle. Check ignition timing. Timing mark on crankshaft pulley and mark on timing belt cover should be aligned to.
3. If timing is not within specification, loosen distributor hold-down bolts and rotate distributor base to adjust. Recheck timing and tighten distributor hold-down bolts to 14-19 ft. lbs. (19-26 N.m).
BASE IGNITION TIMING
ApplicationDegrees @ Idle
1.6L9-11 BTDC
© 2008 Mitchell Repair Information Co., LLC.
Image (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Click here to log in and view diagram.
Jan 17, 2011 at 9:20 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.