1995 Jeep Wrangler transmission not down shifting properly

MY 1ST JEEP

MEMBER
1995 JEEP WRANGLER
2.4L
4 CYL
4WD
AUTOMATIC
140,000 MILES

When coming to a stop when the trans shift down from 2nd the motor revs down and almost dies but as soon as the shift to 1st catches the motor revs right back up and all is good. This happens when slowing for a turn also. If the motor is in 1st when I stop then there is no problem. I have checked fluid - it was high so I drained it to correct level and still have the problem. What can be causing this prob and are there any easy fix solutions such as an additive or something like that?

Saturday, August 16th, 2014 AT 6:52 PM

2 Replies

CJ MEDEVAC II

MEMBER
222 POSTS

MAYBE TAKE THIS THANG OFF AND CLEAN IT WITH THROTTLE BODY CLEANER? INSIDE THE HOLE TOO!

http://shop.advanceautoparts.com/p/bwd-idle-air-control-valve-21775/18480956-P?searchTerm=iac

WHILE YOU ARE AT IT, CLEAN BOTH SIDES OF YOUR THROTTLE PLATE (ACTUATE IT BY HAND TO SEE THE OTHER SIDE)

IF I'M WRONG, YOU ARE OUT A CAN A CLEANER

LET US KNOW HOW IT GOES

THE MEDIC

Image (Click to make bigger)

Was this

answer

helpful?

Yes

No

Saturday, August 16th, 2014 AT 7:15 PM

CARADIODOC

MECHANIC
34,087 POSTS

Hi guys. Excuse me for butting in but it sounds like you have a low idle speed problem. Why are you looking at the transmission? Also, did you check the fluid level with the engine running or off? If you did it with the engine off, the level is going to be real high. It has to be checked with the engine running.

For the low idle speed, if the battery was recently disconnected or run dead, the Engine Computer will have lost its memory and will have to relearn "minimum throttle" before it will know when it has to be in control of idle speed. To meet the conditions for the relearn to take place, drive at highway speed with the engine warmed up, then coast for at least seven seconds without touching the pedals.

Was this

answer

helpful?

Yes

No

Saturday, August 16th, 2014 AT 7:51 PM