Cooling system

1995 JEEP WRANGLER
107,044 MILES • 4 CYL • 4WD • MANUAL
Avatar
MCKENNA27
  • MEMBER
  • 1 POST
I have a 1995 Jeep Wrangler with a 2.5L 4 cylinder engine. I have replaced the thermostat and flushed the cooling system. the coolant does not seem to be moving through the system. I have verified that the thermostat is installed properly. What could be causing this?
May 15, 2011 at 5:49 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
CJ MEDEVAC
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 11,004 POSTS
Was your radiator professionally taken apart, cleaned, and rodded?

'Round here minerals stop 'em up bad! Auto Parts Store's flushes do not cut it!

Are you overheating?--Kinda don't say that up top.

What about Squishy radiator hoses, s.ucking flat, from water pump action.

What about the ole fan clutch?

One I have to ask! (don't ask why!)......Do you have a belt?

Your Turn,

Here to help, all I can!

The Medic
May 15, 2011 at 8:10 PM
Advertisement