1995 Honda Accord Changed Clutch Master Cylinder Slave Getting Little Pressure

1995 HONDA ACCORD
12,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
I changed the clutch master cylinder and the slave cylinder and i am getting little pressure on the clutch it does not sink all the way to the floor but it does not come all the way back up either.
Jan 29, 2013 at 5:10 PM
Advertisement
Avatar
DOCFIXIT
  • ✓ASE Certified Mechanic
  • 18,828 POSTS
  • ASE Certified Mechanic
Most likely air still present put a tube tightly fit on bleeder fill with fluid to submerge hose open bleeder have helper pump pedal slowly till all bubbles gone
Jan 29, 2013 at 5:30 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.