ground circuit on 1995 gmc 1500 sierra

1995 GMC JIMMY
6 CYL • 4WD • AUTOMATIC
Avatar
BOB DAVIDSON
  • MEMBER
  • 6 POSTS
i have problem with 4.3 engine running after it starts up and runs for about half hour, i believe there is abreak somewhere in the ground circuit i added a new ground strap from battery to block where else should i try adding new ground circuit because i feel when driving ignition seems to cut out, then when you let it sit for afew minites it restarts till problem happens all over again
Dec 19, 2010 at 12:49 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
Block to the firewall and on the radiator support housing/frame
Dec 19, 2010 at 12:58 AM
Advertisement
Avatar
BOB DAVIDSON
  • MEMBER
  • 6 POSTS
I sent in reply got no answer
Dec 20, 2010 at 7:44 PM
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
Check and test the ignition switch could be failing
Dec 20, 2010 at 9:08 PM
Avatar
BOB DAVIDSON
  • MEMBER
  • 6 POSTS
how would you test the ignition switch on this model?
Dec 20, 2010 at 9:46 PM
Avatar
BOB DAVIDSON
  • MEMBER
  • 6 POSTS
waiting for reply
Dec 20, 2010 at 11:19 PM
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
Do you have a repair manual this one can be tricky to test cold and hot-checking the input and output voltages on the ignition switch when its breaking internally
Dec 21, 2010 at 12:58 AM