just set the timing on a scorpio 2.0 ltr now engine wont crank by hand
Jul 22, 2011 at 6:08 AM
scorpio
CONFUSED.COM
- MEMBER
- 1 POST
Advertisement
DID YOU MARK ORIGINAL LOCATION?
PUT IT BACK, TO MARK AND STILL WILL NOT START?
WHY DID YOU THINK IT NEEDED TO BE TIMED?
DID YOU GO THRU THE PROPER STEPS TO SET TIMING?
THIS IS NOT YOUR VEHICLE, BUT A PROCEDURE IS A PROCEDURE...DO YOU HAVE PROPER TUNING TOOLS AND REFERENCES?
FOR INSTANCE,
ON ONE OF MY JEEPS, IDLE SPEED MUST BE 700 RPM, REMOVE AND PLUG VACUUM ADVANCE, THEN DO THE PROCEDURE...8 DEGREES BTDC, THEN RECONNECT VACUUM ADVANCE...IT STARTS WITH ABOUT ONE REVOLUTION W/ STARTER OR ROLL STARTING.
MY OTHER JEEP HAS NO VACUUM ADVANCE, IDLE SPEED MUST BE 600 RPM...SET TO 5 DEGREES BTDC. IT EZily STARTS USING THE STARTER AND ROLL STARTING....MY DAUGHTER CAN "HAND CRANK" HIM WITH ABOUT A 1/4 TO 1/2 OF A REVOLUTION.
THE MEDIC
PUT IT BACK, TO MARK AND STILL WILL NOT START?
WHY DID YOU THINK IT NEEDED TO BE TIMED?
DID YOU GO THRU THE PROPER STEPS TO SET TIMING?
THIS IS NOT YOUR VEHICLE, BUT A PROCEDURE IS A PROCEDURE...DO YOU HAVE PROPER TUNING TOOLS AND REFERENCES?
FOR INSTANCE,
ON ONE OF MY JEEPS, IDLE SPEED MUST BE 700 RPM, REMOVE AND PLUG VACUUM ADVANCE, THEN DO THE PROCEDURE...8 DEGREES BTDC, THEN RECONNECT VACUUM ADVANCE...IT STARTS WITH ABOUT ONE REVOLUTION W/ STARTER OR ROLL STARTING.
MY OTHER JEEP HAS NO VACUUM ADVANCE, IDLE SPEED MUST BE 600 RPM...SET TO 5 DEGREES BTDC. IT EZily STARTS USING THE STARTER AND ROLL STARTING....MY DAUGHTER CAN "HAND CRANK" HIM WITH ABOUT A 1/4 TO 1/2 OF A REVOLUTION.
THE MEDIC
Images (Click to enlarge)
Jul 22, 2011 at 6:47 AM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement
parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.