1995 Ford F-350 FRONT WHEEL BEARING ASSEMBLY

1995 FORD F-350
360,000 MILES • 7.3L • V8 • TURBO • 4WD • AUTOMATIC
Avatar
RICHTERRDF
  • MEMBER
  • 1 POST
NEED DRAWING OF BREAKDOWN FOR FRONT AXLE AND BEARING AERA.. WAS ORGINALY 4X4 ON THE FLY BUT AFTER LOTS OF CONTINUAL PROBLEMS FORD SERVICE CHANGED OVER TO MANUEL LOCKING HUBS. I BELIVE I HAVE BEARINGS GOING OUT AND NEED TO WORK ON IT MYSELF.
Apr 21, 2014 at 10:48 AM
Advertisement
Avatar
HMAC300
  • ✓ASE Certified Mechanic
  • 48,601 POSTS
  • ASE Certified Mechanic
Removal
Remove 6 bolts and remove manual locking hub cover. Remove snap ring retaining axle shaft in hub body assembly. Remove locking hub body-to-wheel hub lock ring. Install 2 bolts to remove locking hub body. See Fig. 4.
Installation
To install locking hub, reverse removal procedure. Tighten bolts to 35-53 INCH lbs. (4-6 N.m). DO NOT pack locking hub cover with grease
Image (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Apr 21, 2014 at 12:19 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.