Eagle Vision TSI 1995

1995 EAGLE VISION
6 CYL • FWD • AUTOMATIC
Avatar
DBSTEW10
  • MEMBER
  • 5 POSTS
replaced coil, now it wont start and there is no spark. was told that it could either be the cam shaft sensor or the crank sensor. Is this true. also can not locate them. any help will be appreciated.
Feb 14, 2011 at 6:08 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
RASMATAZ
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 75,992 POSTS
Could be the Camshaft Position Sensor At timing chain end of left cylinder head, near thermostat housing.

Crankshaft Position Sensor On right side of transaxle bellhousing
Feb 14, 2011 at 6:26 PM
Advertisement
Avatar
DBSTEW10
  • MEMBER
  • 5 POSTS
Okay went ahead and replaced both of the Sensors..still won't start plus not getting any spark to the sensors..any ideas as to where to check now..Thank you
Feb 17, 2011 at 10:43 AM