1995 Chrysler Concorde pull a dent in hood

Tiny
ROBYNKATUS123
  • MEMBER
  • 1995 CHRYSLER CONCORDE
  • 3.5L
  • 6 CYL
  • AUTOMATIC
  • 78,000 MILES
I was in a car accident and the guy had no insurance. I need to pull a big dent in my hood. Too deep for the suction cup method. Below is a pic any ideas?
Sunday, June 28th, 2015 AT 11:17 AM

4 Replies

Tiny
JDL
  • MECHANIC
  • 16,098 POSTS
If the picture shows the whole dent, it doesn't look like much? You may be able to drill a series of small holes in the dent then use a slide hammer to pull the dent, one end of the slide hammer screws into the small hole.

Can you tap out the dent from the under side of hood? Or remove the hood, then tap out the dent? I'm really not a body person. I can't tell if headlamp assembly is busted?
Was this
answer
helpful?
Yes
No
Sunday, June 28th, 2015 AT 1:50 PM
Tiny
JDL
  • MECHANIC
  • 16,098 POSTS
If you use small holes, when your finished, you can use body filler or something for the holes. Sand it down and prime it.
Was this
answer
helpful?
Yes
No
Sunday, June 28th, 2015 AT 1:53 PM
Tiny
ROBYNKATUS123
  • MEMBER
  • 2 POSTS
Thank you I will try that. Yes the headlight assembly is broken.
Was this
answer
helpful?
Yes
No
Sunday, June 28th, 2015 AT 4:18 PM
Tiny
JDL
  • MECHANIC
  • 16,098 POSTS
Hope you get it going your way.
Was this
answer
helpful?
Yes
No
Monday, June 29th, 2015 AT 8:27 AM

Please login or register to post a reply.

Sponsored links