I have tried everything and disconnected all wires but it's still wedged and won't drop
Jun 14, 2012 at 4:37 PM
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
KHLOW2008
CAR REPAIR CONTRIBUTOR
41,814 POSTS
Underseals tend act link adhesives and would result in the tank sticking to the underbody and requires some prying to loosen the tank.
Be careful not to damage the tank while prying, unless you are planning to replace it.
Jun 14, 2012 at 5:55 PM
Advertisement
DOCFIXIT
CAR REPAIR CONTRIBUTOR
18,828 POSTS
removed filler pipe? straps?
Jun 14, 2012 at 5:55 PM
SULLIVAN JOE
MEMBER
2 POSTS
I am now having problems releasing wires on top of fuel tank. There is no Locking tab.
Jun 14, 2012 at 6:04 PM
KHLOW2008
CAR REPAIR CONTRIBUTOR
41,814 POSTS
When dirt accumulates at the connector, it can be difficult to relesa the locking tab. Try cleaning the connector first. Compressed air would be ideal, a tooth brush works fine with some spurts of WD-40.
Jun 14, 2012 at 6:12 PM
CADIEMAN
CAR REPAIR CONTRIBUTOR
3,544 POSTS
cut the stupid wires then do a harness repair later.