1995 Chevrolet Silverado Changing Out Motor Disconnect Ignition Control System

1995 CHEVROLET SILVERADO
183,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
Am changing out the motor and it says to disconnect the Ignition Control system to set the timing and I cannot find the black and tan wire that it says in the book to disconnect. Have looked in the wiring harness below the heater case as it says and still can't find the wire. Help!!!!
Jan 2, 2013 at 3:21 AM
Advertisement
Avatar
ASEMASTER6371
  • ✓ASE Certified Mechanic
  • 52,796 POSTS
  • ASE Certified Mechanic
ok, you can jump the aldl connector inside the truck to get base timing. the upper 2 connectors to the right, same as checking codes

Roy
Jan 2, 2013 at 3:23 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.