how do i get out a stuck freeze plug?

1995 CHEVROLET
150,000 MILES
Avatar
JUSTINFORD2
  • MEMBER
  • 1 POST
i got old one out and when i put in new 1,i hit it in too far now it wont come out. Would it be ok to leave it in place or do i need to take it out
Sep 12, 2011 at 11:26 PM
Advertisement
Avatar
CARADIODOC
  • ✓ASE Certified Mechanic
  • 34,321 POSTS
  • ASE Certified Mechanic
Drill a hole in it, then run in a self-tapping screw with the point ground off. Drill near the side, that way it will turn when you drive the bolt in so you can grab it. Be very careful to not drill through the cylinder wall. The core plug is soft and will drill easily. The cylinder wall is hard and will drill slower.
Sep 13, 2011 at 1:09 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.