I recently changed radiator,water pump and thermostat and tried bleeding the system but I get water coming out and then it goes back to running hot
Jun 9, 2014 at 5:01 PM
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
SATURNTECH9
AUTOMOTIVE REPAIR CONTRIBUTOR
30,869 POSTS
Have you had the radiator cap tested yet?Also is the radiator cooling fan turning on at the correct temp?
Jun 9, 2014 at 5:07 PM
Advertisement
RTHOMAS44
MEMBER
4 POSTS
I haven't when I start car up all fluids come out through cap also when bleeding, I get water gushing up but it still is holding a lot of air/pressure
Jun 9, 2014 at 5:39 PM
SATURNTECH9
AUTOMOTIVE REPAIR CONTRIBUTOR
30,869 POSTS
Have you checked to see if there is excessive pressure in the cooling system from maybe a bad head gasket.
Jun 9, 2014 at 6:37 PM
RTHOMAS44
MEMBER
4 POSTS
That is my next plan of action change gaskets and cap
Jun 9, 2014 at 6:45 PM
SATURNTECH9
AUTOMOTIVE REPAIR CONTRIBUTOR
30,869 POSTS
Before you change the head gasket I would make sure its bad.You can rent a chemical head gasket tester at auto zone for free y o u just have to by the chemical for it.
Jun 9, 2014 at 6:50 PM
RTHOMAS44
MEMBER
4 POSTS
I recently noticed the coolant isn't circulating properly out top radiator hose into engine. Also fan isn't coming on when. When vehicle runs hot